Printing to the E-24B
If the customer can print the E-24B Test Page but cannot print a job from a computer on the network, you
may have to make a service call. However, first make sure that the site administrator has done the
following:
•
Checked all components of the network, including cables, connectors, terminators, network
adapter boards, and network drivers.
• Activated the network and used it to communicate with other printers.
• Confirmed that the applicable network settings in Setup (such as AppleTalk zone, IP address,
subnet mask, and gateway address) match the settings used in the network.
When you make a service call, check the E-24B connector panel to make sure that the appropriate
network connection is in place. Print quality problems are difficult to trace. Before you try to troubleshoot
print quality problems, print a Test Page to make sure that the copier does not need servicing or
adjusting. Also, make sure that the correct paper is being used in the copier.
• EPS file generation is not completely standardized among applications. Some users may encounter
problems while printing certain EPS files.
If the Copier Does Not Print
The following table lists possible causes and solutions when the copier does not print.
Table 1: Causes and solutions when copier does not print
Possible Cause Solution
Is the power ON?
Turn ON the E-24B using the power switch and the copier
power switch.
Are the cables between the E-24B
and the copier connected?
Make sure that the copier interface cables are completely and
correctly connected to the copier and the E-24B.
Is the specified paper loaded? Load the specified paper in any of the input trays.
Can you print a Test Page from the
printer driver?
If you cannot print the Test Page, the copier may be out of
order. You may need to service the copier.
Is the chassis fan present and
functioning?
Verify that the chassis fan is present, oriented correctly, and
functioning.
Other Printing Problems
The following table lists other printing problems and what to do about them.
5. Troubleshooting
180