Important Notes for Activation
1. If you have multiple Fiery options to activate, you must activate them one at a time. It is not possible
to activate several options at once.
2.
If the keychip (Server Options) or PC (Client Options) becomes defective, the following's are
needed as evidence in order to get recovered.
• Defective key chip
• LAC
• Option Name
• Serial Number of E-24B
• OS on the client PC where the software was installed.
• The configuration page that shows that the defective key chip had the optional feature license
installed.
Therefore, please be sure that you always print a configuration page and note the above
information and keep them together when you activate a new optional feature on the E-24B.
Automatic Activation and Manual Activation
There are two ways to activate the optional features: "Automatic" and "Manual".
Required Environment for Automatic Activation:
<Server Options>
1.
The E-24B must be connected to the Internet.
• If the E-24B is not connected to the Internet directly, you can configure a proxy server for
the connection.
2.
At the same time, a PC that can access to E-24B with the web browser is needed.
• You can also start the activation procedure with the Command WorkStation, but later
web browser access is required.
<Client Options>
1.
The PC where the optional feature will be installed and used must be connected to the
Internet.
2. At the same time, the same PC needs to access to E-24B with Command WorkStation and
web browser.
Required Environment for Manual Activation:
<Server Options>
1. Installation
28
To Next Page
Loading...
Need help?
General
