• The machine does not enter the energy saving mode in the following cases:
• When fixed warm-up is in progress
• When operations are suspended during printing
• When a screen that does not support Auto Logout is displayed
• The machine does not enter Low Power Mode (Energy Saving Priority) in the following cases:
• When the covers of the machine including the covers of the external options are open
• When a user is operating on the control panel of the machine (excluding operations from a
client computer)
• The machine does not enter Sleep Mode in the following cases:
• When the machine is warming up
• When the machine is initializing its data
• When the machine is preparing to restart
• When receiving remote support from a call center
• When the machine is performing Image Position adjustment
• When performing a Batch Update of the system
• When outputting the device information of the machine
• Even when the machine is in the energy saving mode, you can connect remotely to the machine
from the web browser on a client computer as long as the printer controller remains turned on.
Anti-humidity Heater Switch
During winter or humid periods when there can be sudden changes in temperature and humidity, the
paper in the paper trays can absorb moisture. This may cause image quality to deteriorate.
To prevent this, the machine has two built-in anti-humidity heaters.
There are two switches for the anti-humidity heaters on the internal cover which is revealed when the
Tray 1 is pulled out. Turn these switches on if the humidity level becomes high and image quality is
affected. Turn the switches off at other times.
The left switch is for the paper tray heater and the right switch is for the transfer unit heater.
Turning On and Off the Power
17
To Next Page
Loading...
General
