• Toner fixation deteriorates when you increase the toner adhesion amount, and splashing or
smearing of characters and hairlines may occur.
0203: Line Width
Adjust laser beam for image data writing. Halftone dot and fine line becomes thicker when laser beam
increases. After setting change, image density is adjusted automatically before print start.
Setting Items
Default
Value
Max.
Value
Min.
Value
Step Unit
01: Black
02: Cyan
03: Magenta
04: Yellow
05: Special
*1
0 5 -5 1 None
*1
5th station upgrade kit is required.
• Screen dots and hairline width become thicker when you increase the intensity.
0204: Density Difference: Across Feed
Adjust the image density difference in the vertical direction. Use [ ] or [ ] to increase or decrease the
density of lower part of image.
• Depending on the machine's other settings, this setting may have no effect.
Setting Items
Default
Value
Max.
Value
Min.
Value
Step Unit
01: 1st Station
02: 2nd Station
03: 3rd Station
04: 4th Station
05: 5th Station
*1
0 10 -10 1 None
5. Adjustment Settings for Operators
202
To Next Page
Loading...
Need help?
General
