2. Paper Specifications and Adding
Paper
Loading Paper into the Paper Tray
The method of loading paper varies for each tray type.
• When pulling out the paper tray, do not pull it out swiftly. The tray may fall and cause injury.
• When replacing paper or removing jammed paper, make sure not to trap or injure your fingers.
Interposer
Perfect binder
Multi bypass tray (Tray A)
*2
Wide LCT
*3*4
Tray 1
*1
Tray 3
Tray 2
Tray 4
M0EBIM2107
*1
The A3/11 × 17 tray unit can be attached.
*2
The banner sheet tray of multi bypass tray (Tray A) can be attached.
*3
You can attach LCT banner sheet tray on the topmost tray among trays 3, 5, and 7.
*4
You can attach Extension LCT banner sheet tray on the topmost tray among trays 3,5, and 7.
• Even if paper is loaded as described above, normal operations and print quality might still not be
possible, depending on the paper type.
• When loading 40.0–52.3 g/m
2
(11.0 lb. Bond–14.0 lb. Bond) paper into paper trays or loading
translucent paper into the wide LCT or the multi bypass tray (Tray A), always use long grain paper.
• Before loading paper into a tray, check the paper size and type that can be loaded in the tray,
and confirm the paper size that is automatically detected.
See page 101 "Recommended Paper Sizes and Types".
• When loading paper of a size that is not automatically detected, specify the paper size in the
paper settings on the [Media] hub.
page 98 "Specifying the Paper Size That Is Not Automatically Detected"
69
To Next Page
Loading...
Need help?
General
