Siemens SINUMERIK ONE MCP 2400.4c Operation/Programming

9
08/2005 Program Management
9.2 Mana
g
in
g
p
ro
g
rams with Sho
p
Turn on NCU
(
HMI Embedded
)
9
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition 9-381
9.2.5 Marking several programs
You can select several programs individually or in a block for
subsequent copying, deleting, etc.
Selecting several
programs as a block
 Open the Program Manager.
 Place the cursor on the first program that you want to select.
Mark
 Press the "Mark" softkey.
-or-
 Expand the program selection area by pressing the cursor up or
down key.
The entire block of programs is marked.
Selecting several
programs individually
 Open the Program Manager.
 Place the cursor on the first program that you want to select.
 Press the "Select" key.
-or-
 Move the cursor to the next program that you want to select.
 Press the "Select" key again.
The individually selected programs are marked.

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General

Brand	Siemens
Model	SINUMERIK ONE MCP 2400.4c
Category	Control Systems
Language	English