CYLINDER HEAD, CYLINDER AND PISTON 6-21
CYLINDER INSPECTION
CYLINDER DISTORTION
• Check the gasketed surface of the cylinder for distortion with
a straightedge and thickness gauge, taking a clearance read-
ing at several places indicated.
• If the largest reading at any position of the straightedge
exceeds the limit, replace the cylinder.
Cylinder distortion:
Service Limit: 0.05 mm (0.002 in)
09900-20803: Thickness gauge
CYLINDER BORE
• Inspect the cylinder wall for any scratches, nicks or other
damage.
• Measure the cylinder bore diameter at six places.
Cylinder bore:
Standard: 77.000 – 77.015 mm (3.0301 – 3.0307 in)
09900-20530: Cylinder gauge set
ECT SENSOR REMOVAL
(12-62)
ECT SENSOR INSPECTION
(12-62)
ECT SENSOR INSTALLATION
(12-63)
To Next Page
Loading...
Need help?
General
