19-12 REAR SUSPENSION
INSTALLATION
Install the rear shock absorber in the reverse order of removal.
Pay attention to the following points:
• Tighten the rear shock absorber lower mounting bolt and nut
1 to the specified torque.
NOTE:
If necessary, move the swingarm up or down to facilitate this
mounting bolt/nut tightening.
Rear shock absorber lower mounting nut:
50 N·m (5.0 kgf-m, 36.0 lbf-ft)
• Tighten the upper mounting bolt and nut 2 to the specified
torque.
Rear shock absorber upper mounting nut:
50 N·m (5.0 kgf-m, 36.0 lbf-ft)
DISPOSAL
High pressure nitrogen gas is sealed in the rear shock absorber
unit. Be sure to release gas before disposing the rear shock
absorber unit.
• Remove the valve cap 1.
• Press the valve with a screwdriver.
* Releasing high pressure gas from the rear shock
absorber unit can be hazardous.
* Place a rag over the valve and push the valve with a
screwdriver to release nitrogen gas. Do not use your
finger to push the valve, and direct the valve away
from your face and body.
To Next Page
Loading...
Need help?
General
