Suzuki RM-Z250 Service Manual

FI SYSTEM DIAGNOSIS 12-61
SENSORS
CKP SENSOR/CRANKSHAFT ROTATION
SIGNAL SENSOR INSPECTION
The CKP sensor 1 and crankshaft rotation signal sensor 2 are
installed at the inside of the magneto cover. (12-29, -58)
CKP SENSOR/CRANKSHAFT ROTATION
SIGNAL SENSOR REMOVAL AND INSTAL-
LATION
• Remove the magneto cover. (15-17)
• Remove the CKP sensor and crankshaft rotation signal sen-
sor. (15-19)
• Install the CKP sensor and crankshaft rotation signal sensor
in the reverse order of removal.
IAP SENSOR INSPECTION
The IAP sensor 1 is installed on the throttle body. (12-39)
IAP SENSOR REMOVAL AND INSTALLATION
• Remove the fuel tank. (13-2, -3)
• Remove the IAP sensor from the throttle body. (13-10)
• Install the IAP sensor in the reverse order of removal.
TP SENSOR INSPECTION
The TP sensor 1 is installed at the left side of the throttle body.
(12-31)
TP SENSOR REMOVAL AND INSTALLATION
• Remove the TP sensor. (13-9)
• Install the TP sensor in the reverse order of removal.
• Adjust the TP sensor. (12-18)

Suzuki RM-Z250 Specifications

General

Brand	Suzuki
Model	RM-Z250
Category	Motorcycle
Language	English