Suzuki RM-Z250 Service Manual

19-6 REAR SUSPENSION
BEARING REPLACEMENT
• Remove the spacers.
• Remove the needle roller bearings 1. (26 pieces of needle
roller bearing)
• Remove the dust seals 2.
• Remove the needle roller bearing cage 3 with the special
tool.
 09921-20240: Bearing remover set (Remover 17 mm)
• Press the new needle roller bearing cage with the special tool
and a suitable size socket wrench.
NOTE:
When installing the needle roller bearing cage 3, the stamped
mark on the bearing must face left side.
Position the needle roller bearing cage by referring to the illus-
tration of page 19-22.
 09924-84521: Bearing installer set
• Press the new dust seals 4 with the special tool and a suit-
able size socket wrench.

NOTE:
When installing the dust seal 4, the stamped mark A on the
dust seal 4 must face inside.
 09924-84521: Bearing installer set
• Apply grease to the needle roller bearings and install them.
• Apply grease to the dust seals and spacers.
• Install the spacers B and C.
B For right side
C For left side
 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
Replace the dust seal 4 with new ones.

Suzuki RM-Z250 Specifications

General

Brand	Suzuki
Model	RM-Z250
Category	Motorcycle
Language	English