18-6 FRONT FORK AND STEERING
DISASSEMBLY
• Set rebound and compression damper settings to the mini-
mum settings (softest) before disassembling. Record the set-
ting before turning the adjuster.
• Thoroughly clean the fork before disassembly.
• Clamp the outer tube 2 with a vise. Protect the outer tube
with a rag when using a vise.
• Loosen and remove the fork cap bolt 1 (sub-tank) from the
outer tube with the special tool and slowly slide down the
outer tube.
09941-53630: Front fork cap socket wrench (50 mm)
• Place a drain pan under the front fork and drain fork oil.
NOTE:
Face the oil hole A on the sub-tank downward.
• Raise the outer tube and temporarily install the fork cap bolt
1 (sub-tank) to the outer tube.
* Scratches or other damage on the inner tube or on
the oil seal lip will cause oil leakage.
* Avoid scratching or damaging the inner tube or the
oil seal. Use a mild detergent or car wash soap and
sponge out dirt with plenty of water.
* Clamping the outer tube too tight can damage it
which will affect riding stability.
* Be careful not to clamp the outer tube too tight.
To Next Page
Loading...
Need help?
General
