6-26 CYLINDER HEAD, CYLINDER AND PISTON
PISTON AND PISTON RING INSTALLATION
Install the piston and piston ring in the reverse order of removal.
Pay attention to the following points:
PISTON RING
• Install the piston rings in the order of oil ring and 1st ring.
• The first member to go into the oil ring groove is a spacer 1.
After placing the spacer, fit the two side rails 2.
NOTE:
Side designations, top and bottom, are not applied to the spacer
and side rails: you can position each either way.
A INCORRECT
B CORRECT
• Install the 1st ring so that the “IR” mark C faces up.
• Position the gaps of the two ring as shown. Before inserting a
piston into the cylinder, check that the gaps are so located.
D 1st ring
E Upper side rail
F Spacer
G Lower side rail
When installing the spacer 1, be careful not to allow
its two ends to overlap in the groove.
IN.
EX.
To Next Page
Loading...
Need help?
General
