Valtra T series Versu User Manual

Symbol Operation Switch positions when
running a programme
Limitation
Current socket
deactivated.
1)
PAUSE
Pause in the programme.
END
End of the programme.
1)
The system checks the correct positions of these switches before recording and running. If the
position is incorrect, the symbol of the operation flashes on the display.
2)
The system does not check the adjustments of this equipment; they must be checked and
adjusted by the operator.
3)
The function is not possible if the valve controls the front loader.
4)
If these operations are in the AUTO mode when recording, the operation is not recorded. If the
operation is recorded and the switch is turned to AUTO position before use, the switch is
dominant. In that case, the recorded operations of that switch do not occur.
The rear PTO is an exception. The AUTO mode of the rear PTO cannot be active together with
the U-Pilot.
3.19.5 U-Pilot programme examples
Example
Using a reversible plough
Coming to headland:
Lift of the plough.
Four-wheel drive (4WD) disengaged.
Differential lock disengaged.
PS 1
Powershift gear 1.
10
s
+
3R
Reversion of the plough.
END
End of the programme.
Leaving the headland:
Lowering of the plough.
4WD engaged.
Differential lock engaged.
PS 2
Powershift gear 2.
END
End of the programme.
3. Operation
- 253 -

Valtra T series Versu Specifications

General

Brand	Valtra
Model	T series Versu
Category	Tractor
Language	English