24
Configuring SNMP Community Names with Internet Services
1. Open your Web browser and enter the TCP/IP address of the Device in the Address or Location field.
Press Enter.
2. Click the Properties Tab.
3. Click the plus symbol (+) to the left of the Protocol Settings file folder.
4. Select SNMP in the directory tree.
5. Enter a name for the Community Name (Read-Only). This is the password for SNMP GET requests
from the SNMP Manager to the Agent in the Device.
6. Enter a name for the Community Name (Read-Write). This is the password for SNMP SET
requests from the SNMP Manager to the Agent in the Device.
7. Caution: If you change the GET and/or SET Community Names, you must also change the names in
all network applications that are communicating by SNMP with this Device.
8. Enter a name for the Community Name (Trap Notification). This is the default password for SNMP
TRAPS sent from the device to the Manager by SNMP.
9. Optionally enter the System Administrator's name for packet identification purposes.
10. Click Apply to accept the changes, or Undo to return the settings to their previous values.
Note: Changes to settings will not be applied until you restart the Device.
To Next Page
Loading...
Need help?
General
