257
Configure LPD N5.6
1. Open your Web browser and enter the TCP/IP address of the Device in the Address or Location field.
Press Enter.
2. Click the Properties tab.
3. Click the plus symbol (+) to the left of the Protocol Settings file folder.
4. Select LPD in the directory tree.
5. The available selections include:
Port Number, with a default value of 515. As this is the port for the TCP Spooler assigned by the
IANA (Internet Assigned Numbers Authority), the default value should not need to be changed.
A TBCP Filter checkbox (displayed when PostScript is enabled).
Connection Time-Out entry box.
6. Enter a Time Out value for jobs being sent to the Device through this Port. This is the length of time
that the Controller will wait for an end of job command before printing the current job.
7. Click the Apply button to accept the changes, or the Undo button to return the settings to their
previous values.
Note: Changes to settings are not applied until you restart the Device. A Reboot Machine button is
available on the Status Tab of Internet Services.
To Next Page
Loading...
Need help?
General
