252
Configure NetWare Settings N5.2
1. Open your Web browser and enter the TCP/IP address of the Device in the Address or Location field.
Press Enter.
2. Click the Properties tab.
3. Click the plus symbol (+) to the left of the Protocol Settings file folder.
4. Select NetWare in the directory tree. Note: If NetWare is not displayed, click on Port Status to see if
the NetWare Port is checked (enabled).
5. The available selections include:
• A Host Name (Print Server) Text box. Use this name to create the Print Server (in Bindery) and
Print Server object (in NDS).
• An Active Mode selection box for Directory (NDS) or Bindery.
• A (Primary) File Server Name entry box (Bindery).
• A Polling Interval entry box for Queue Polling Interval (1 - 1000 seconds).
• A Number of Searches entry box for SAP frequency (1 - 100 seconds, with the ability to set to
zero, which is off).
• Two Password text boxes for logging into the NetWare Server.
• A TBCP Filter checkbox (displayed when PostScript is enabled).
• Under the NDS Subject Label there is a text box for Tree, followed by one for Context.
• A Frame Selection box, with a default of Auto (auto sensing). Other selections include Ethernet II
(used when running TCP/IP on your network), Ethernet 802.3 (used for NetWare versions up to
3.11), Ethernet 802.2 (the default for NetWare 3.12 and later), and Ethernet SNAP (used on
networks running TCP/IP and/or AppleTalk).
• A display of the Device's Network (MAC) address.
• A Service Location Protocol (SLP) Active Search Enablement box. For use with NetWare 5 and
newer versions, this protocol helps to reduce service advertising network traffic.
To Next Page
Loading...
Need help?
General
