ABB ACS560 User Manual

12 Introduction to the manual
Purpose of the manual
This manual provides information needed for designing, commissioning, or operating
the drive system.
Contents of this manual
The manual consists of the following chapters:
• Introduction to the manual (this chapter, page 11) describes applicability, target
audience, purpose and contents of this manual. At the end, it lists terms and
abbreviations.
• Start-up, control with I/O and ID run (page 19) describes how to start up the drive
as well as how to start, stop, change the direction of the motor rotation and adjust
the motor speed through the I/O interface.
• Using the control panel (page 31) contains instructions for removing and
reinstalling the assistant control panel and briefly describes its display, keys and
key shortcuts.
• Program features (page 33) describes program features with lists of related user
settings, actual signals, and fault and warning messages.
• Control macros (page 101) contains a short description of each macro together
with a connection diagram. Macros are pre-defined applications which will save
the user time when configuring the drive.
• Parameters (page 161) describes the parameters used to program the drive.
• Additional parameter data (page 375) contains further information on the
parameters.
• Fault tracing (page 409) lists the warning and fault messages with possible
causes and remedies.
• Fieldbus control through the embedded fieldbus interface (EFB) (page 437)
describes the communication to and from a fieldbus network using the embedded
fieldbus interface of the drive.
• Fieldbus control through a fieldbus adapter (page 467) describes the
communication to and from a fieldbus network using an optional fieldbus adapter
module
• Control chain diagrams (page 485) describes the parameter structure within the
drive.
• Parameterization with drive composer (page 505) describes about managing the
drive parameters with drive composer application.
• Parameterization with automation builder drive manager (page 509) describes
about managing the drive parameters with automation builder drive manager
application.
• Further information (inside of the back cover, page 513) describes how to make
product and service inquiries, get information on product training, provide
feedback on ABB Drives manuals and find documents on the Internet.

ABB ACS560 Specifications

General

Frequency	50/60 Hz
Control Method	Scalar control
Protection Features	Overcurrent, overvoltage, undervoltage, short circuit
Communication Interfaces	Modbus RTU, Profibus DP, CANopen, Ethernet/IP
Enclosure Rating	IP21
Ambient Temperature	-10 to +50 °C
Input Voltage	380 to 480 V AC
Cooling Method	Air cooling (natural convection or forced ventilation)