ABB ACS560 User Manual

Parameterization with automation builder drive manager 509
13
Parameterization with
automation builder drive
manager
Contents of this chapter
The chapter describes about the automation builder drive manager application and
how drive parameters can be managed with the automation builder drive manager.
Automation builder drive manager
Automation builder drive manager is a software tool that enables you to configure
ABB drives connected to the PLC through PROFIBUS or PROFINET.
You can perform the following actions with the automation builder drive manager:
• Monitor the drive status like Running, Stopped, EXT1/EXT2 and Running
direction.
• Monitor the drive parameter groups and parameters.
• Monitor the drive firmware version and properties.
• Monitor the drive parameter values along with the parameter attributes like
parameter minimum and maximum settings, parameter units and parameter
protection status.
• User can edit parameters in offline view and then copy to drive when online.
• Open the offline drive parameter settings (project view) and compare to the online
drive parameters. The compare function shows the parameters with different

ABB ACS560 Specifications

General

Frequency	50/60 Hz
Control Method	Scalar control
Protection Features	Overcurrent, overvoltage, undervoltage, short circuit
Communication Interfaces	Modbus RTU, Profibus DP, CANopen, Ethernet/IP
Enclosure Rating	IP21
Ambient Temperature	-10 to +50 °C
Input Voltage	380 to 480 V AC
Cooling Method	Air cooling (natural convection or forced ventilation)