Barco DP2K SLP Series Service Manual

R5906848 /04 DP2K SLP Series180
• PURPLE : When pushing the Shift, Zoom or Focus button the backlight color is purple of the part of the
button that is pushed. This indicates that the requested action is ongoing.
• RED : The backlight color of the Shift, Zoom and Focus buttons is red in case of end of range.
16.7 Removal of the Lens Holder cover plate
To remove the Lens Holder cover plate the large dust filter at the projector front has to be removed
first. This procedure assumes that this component is already removed.
Required tools
Phillips screwdriver PH2.
How to remove the cover plate of the Lens Holder?
1. Remove the lens from the projector. See chapter “Lens removal”, page 178.
2. Remove the large dust filter from the projector. See chapter “Check the large dust filter”, page 284.
3. Remove the rubber dust ring from the Lens Holder front plate.
Image 16-15
4. Remove the screw (reference 1 Image 16-16) at the lower left side of the cover plate (seen from the front of
the projector). Use a Phillips screwdriver PH2.
5. Remove the three screws (reference 2 Image 16-16) of the cover plate. Use a Phillips screwdriver PH2.
6. Remove the Lens Holder cover plate from the projector.
Lens Holder

Barco DP2K SLP Series Specifications

General

Brand	Barco
Model	DP2K SLP Series
Category	Projector
Language	English