Cisco 7604 User Manual

8-9
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Chapter 8 Configuring RPR and RPR+ Supervisor Engine Redundancy
Copying Files to an MSFC
This example shows how to perform an FSU:
Router# config terminal
Router(config)# config-register 0x2102
Router(config)# boot system flash disk0:
image_name
Router# copy running-config start-config
Router# hw-module reset
Router# redundancy force-switchover
Router#
Copying Files to an MSFC
Use the following command to copy a file to the bootflash: device on an active MSFC:
Router# copy source_device : source_filename bootflash: target_filename
Use the following command to copy a file to the bootflash: device on a redundant MSFC:
Router# copy source_device : source_filename slavebootflash: target_filename
Step 4
Router# hw-module { module num } reset
Reloads the redundant supervisor engine and brings it
back online (running the new version of the Cisco IOS
software).
Note Before reloading the redundant supervisor
engine, make sure you wait long enough to ensure
that all configuration synchronization changes
have completed.
Step 5
Router# redundancy force-switchover
Conducts a manual switchover to the redundant
supervisor engine. The redundant supervisor engine
becomes the new active supervisor engine running the
new Cisco IOS image. The modules are reloaded and the
module software is downloaded from the new active
supervisor engine.
The old active supervisor engine reboots with the new
image and becomes the redundant supervisor engine.
Note To perform an EHSA to RPR FSU, use the reload
command in Step 5.
Command Purpose
Step 1
Router# copy source_device : source_filename {disk0
| disk1}:
target_filename
Copies the new Cisco IOS image to the disk0: device or
the disk1: device on the active supervisor engine.
Or:
Router# copy source_device : source_filename
sup-bootflash:
target_filename
Copies the new Cisco IOS image to the bootflash:
device on the active supervisor engine.
Or:
Router# copy source_device : source_filename
{slavedisk0 | slavedisk1}:
target_filename
Copies the new Cisco IOS image to the disk0: device or
the disk1: device on the redundant supervisor engine.
Or:
Router# copy source_device : source_filename
slavesup-bootflash:
target_filename
Copies the new Cisco IOS image to the bootflash:
device on the redundant supervisor engine.

Cisco 7604 Specifications

General

Brand	Cisco
Model	7604
Category	Network Router
Language	English