Cisco 7604 User Manual

CHAPTER
26-1
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
26
Configuring IP Unicast Layer 3 Switching
This chapter describes how to configure IP unicast Layer 3 switching on the Cisco 7600 series routers.
Note For complete syntax and usage information for the commands used in this chapter, refer to these
publications:
• The Cisco IOS Master Command List, Release 12.2SX at this URL:
http://www.cisco.com/en/US/docs/ios/mcl/122sxmcl/12_2sx_mcl_book.html
• The Release 12.2 publications at this URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_installation_and_configuratio
n_guides_list.html
• IPX traffic is fast switched on the MSFC. For more information, refer to this URL:
http://www.cisco.com/en/US/docs/ios/12_2/atipx/configuration/guide/fatipx_c.html
• For information about IP multicast Layer 3 switching, see Chapter 28, “Configuring IPv4 Multicast
Layer 3 Switching.”
This chapter consists of these sections:
• Understanding How Layer 3 Switching Works, page 26-2
• Default Hardware Layer 3 Switching Configuration, page 26-4
• Configuration Guidelines and Restrictions, page 26-4
• Configuring Hardware Layer 3 Switching, page 26-5
• Displaying Hardware Layer 3 Switching Statistics, page 26-6
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html

Cisco 7604 Specifications

General

Brand	Cisco
Model	7604
Category	Network Router
Language	English