Cisco 7604 User Manual

CHAPTER
22-1
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
22
Configuring Layer 3 Interfaces
This chapter contains information about how to configure Layer 3 interfaces on the Cisco 7600 series
routers.
Note For complete syntax and usage information for the commands used in this chapter, refer to these
publications:
• The Cisco IOS Master Command List, Release 12.2SX at this URL:
http://www.cisco.com/en/US/docs/ios/mcl/122sxmcl/12_2sx_mcl_book.html
• The Release 12.2 publications at this URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_installation_and_configuratio
n_guides_list.html
This chapter consists of these sections:
• Layer 3 Interface Configuration Guidelines and Restrictions, page 22-2
• Configuring Subinterfaces on Layer 3 Interfaces, page 22-2
• Configuring IPv4 Routing and Addresses, page 22-4
• Configuring IPX Routing and Network Numbers, page 22-8
• Configuring AppleTalk Routing, Cable Ranges, and Zones, page 22-9
• Configuring Other Protocols on Layer 3 Interfaces, page 22-10
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html

Cisco 7604 Specifications

General

Brand	Cisco
Model	7604
Category	Network Router
Language	English