22-10
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Chapter 22 Configuring Layer 3 Interfaces
Configuring Other Protocols on Layer 3 Interfaces
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# appletalk routing
Router(config)# interface vlan 100
Router(config-if)# appletalk cable-range 100-100
Router(config-if)# appletalk zone Engineering
Router(config-if)# no shutdown
Router(config-if)# end
Router# copy running-config startup-config
Configuring Other Protocols on Layer 3 Interfaces
Refer to these publications for information about configuring other protocols on Layer 3 interfaces:
• Cisco IOS Apollo Domain, VINES, DECnet, ISO CLNS, and XNS Configuration Guide,
Release 12.2, at this URL:
http://www.cisco.com/en/US/docs/ios/12_2/apollo/configuration/guide/fapolo_c.html
• Cisco IOS Apollo Domain, VINES, DECnet, ISO CLNS, and XNS Command Reference,
Release 12.2, at this URL:
http://www.cisco.com/en/US/docs/ios/12_2/apollo/command/reference/fapolo_r.html
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html