26-6
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Chapter 26 Configuring IP Unicast Layer 3 Switching
Displaying Hardware Layer 3 Switching Statistics
Displaying Hardware Layer 3 Switching Statistics
Hardware Layer 3 switching statistics are obtained on a per-VLAN basis.
To display hardware Layer 3 switching statistics, perform this task:
This example shows how to display hardware Layer 3 switching statistics:
Router# show interfaces gigabitethernet 9/5 | include Switched
L2 Switched: ucast: 8199 pkt, 1362060 bytes - mcast: 6980 pkt, 371952 bytes
L3 in Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes mcast
L3 out Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes
To display adjacency table information, perform this task:
This example shows how to display adjacency statistics:
Router# show adjacency gigabitethernet 9/5 detail
Protocol Interface Address
IP GigabitEthernet9/5 172.20.53.206(11)
504 packets, 6110 bytes
00605C865B82
000164F83FA50800
ARP 03:49:31
Note Adjacency statistics are updated approximately every 60 seconds.
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Command Purpose
Router# show interfaces {{
type
1
slot/port
} |
{port-channel
number
}}
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
Displays hardware Layer 3 switching statistics.
Command Purpose
Router# show adjacency [{{
type
1
slot/port
} |
{port-channel
number
}} | detail | internal | summary]
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
Displays adjacency table information. The optional detail
keyword displays detailed adjacency information, including
Layer 2 information.
To Next Page
Loading...
Need help?
General
