Cisco 7604 User Manual

9-4
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Chapter 9 Configuring Interfaces
Configuring a Range of Interfaces
Note You do not need to add a space between the interface type and interface number. For example,
in the preceding line you can specify either fastethernet 5/5 or fastethernet5/5.
Step 6 After each interface command, enter the interface configuration commands your particular interface
requires.
The commands you enter define the protocols and applications that will run on the interface. The
commands are collected and applied to the interface command until you enter another interface
command or press Ctrl-Z to get out of interface configuration mode and return to privileged EXEC
mode.
Step 7 After you configure an interface, check its status by using the EXEC show commands listed in
“Monitoring and Maintaining Interfaces” section on page 9-17.
Configuring a Range of Interfaces
The interface-range configuration mode allows you to configure multiple interfaces with the same
configuration parameters. After you enter the interface-range configuration mode, all command
parameters you enter are attributed to all interfaces within that range until you exit out of the
interface-range configuration mode.
To configure a range of interfaces with the same configuration, perform this task:
When configuring a range of interfaces, note the following information:
• For information about macros, see the “Defining and Using Interface-Range Macros” section on
page 9-6.
• You can enter up to five comma-separated ranges.
• You are not required to enter spaces before or after the comma.
• With releases earlier than Release 12.2(18)SXE, you must add a space between the interface
numbers and the dash when using the interface range command. For example, interface range
fastethernet 1 - 5 is valid syntax; interface range fastethernet 1-5 is invalid.
• With Release 12.2(18)SXE and later releases, you do not need to add a space between the interface
numbers and the dash when using the interface range command.
• With releases earlier than Release 12.2(18)SXD, the no interface range command does not support
VLAN interfaces.
• With Release 12.2(18)SXD and later releases, the no interface range command supports VLAN
interfaces.
Command Purpose
Router(config)# [no] interface range
{{vlan
vlan_ID - vlan_ID [, vlan vlan_ID - vlan_ID ]}
| {
type
1
slot/port - port [, type
1
slot/port - port ]}
| {
macro_name [, macro_name ]}}
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
Selects the range of interfaces to be configured.

Cisco 7604 Specifications

General

Brand	Cisco
Model	7604
Category	Network Router
Language	English