EasyManuals Logo
Home>Cisco>Network Router>7604

Cisco 7604 User Manual

Cisco 7604
1011 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #472 background imageLoading...
Page #472 background image
30-12
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Chapter 30 Configuring IGMP Snooping for IPv4 Multicast Traffic
Configuring IGMP Snooping
To configure the interval for the IGMP snooping queries sent by the router, perform this task:
This example shows how to configure the IGMP snooping query interval:
Router(config-if)# ip igmp snooping last-member-query-interval 200
Router(config-if)# exit
Router# show ip igmp interface vlan 200 | include last
IGMP snooping last member query interval on this interface is 200 ms
Enabling IGMP Fast-Leave Processing
To enable IGMP fast-leave processing in a VLAN, perform this task:
This example shows how to enable IGMP fast-leave processing on the VLAN 200 interface and verify
the configuration:
Router# interface vlan 200
Router(config-if)# ip igmp snooping fast-leave
Configuring fast leave on vlan 200
Router(config-if)# end
Router# show ip igmp interface vlan 200 | include fast-leave
IGMP snooping fast-leave is enabled on this interface
Router(config-if)#
Configuring Source Specific Multicast (SSM) Mapping
Note Release 12.2(18)SXD3 and later releases support SSM mapping.
Do not configure SSM mapping in a VLAN that supports IGMPv3 multicast receivers.
To configure SSM mapping, refer to this publication:
http://www.cisco.com/en/US/docs/ios/12_3t/12_3t2/feature/guide/gtssmma.html
Command Purpose
Step 1
Router(config)# interface vlan
vlan_ID
Selects a VLAN interface.
Step 2
Router(config-if)# ip igmp snooping
last-member-query-interval
interval
Configures the interval for the IGMP snooping queries
sent by the router. Default is 1 second. Valid range is 100
to 999 milliseconds.
Router(config-if)# no ip igmp snooping last
Reverts to the default value.
Command Purpose
Step 1
Router(config)# interface vlan
vlan_ID
Selects a VLAN interface.
Step 2
Router(config-if)# ip igmp snooping fast-leave
Enables IGMP fast-leave processing in the VLAN.
Router(config-if)# no ip igmp snooping fast-leave
Disables IGMP fast-leave processing in the VLAN.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7604 and is the answer not in the manual?

Cisco 7604 Specifications

General IconGeneral
BrandCisco
Model7604
CategoryNetwork Router
LanguageEnglish

Related product manuals