Digi Connect EZ Mini User Manual

Serial port Advanced RealPort configuration without using the Digi Navigator
Digi Connect EZ Mini User Guide
167
5. Set the sharing mode:
(config)> serial port1 sharing value
(config)>
where value is one of:
n none: Only the user that opened the port can change the port settings. All other users
are rejected. No other users can receive data from the port. This is the default.
n peer: Any user that tries to open the port can change the port settings. All users that try
to open the port receive all of the data read to the port.
n primary: Only the user that opened the port can change the port settings. All other
users that try to open the port receive all of the data read to the port.
6. Set the signal mode:
(config)> serial port1 signal mode value
(config)>
where value is one of:
Set the signaling interface type used on this serial port:
n rs-232
l Enable rts_toggle if you want to enable RTStoggling during transmission on this
serial port. If enabled, this setting overrides RTS\CTSflow control:
(config)> serial port1 rts_toggle true
(config)>
l For rts_pre_delay, enter the amount of time RTSis asserted before starting data
transmission. The time is measured in milliseconds. The default is 0ms:
(config)> serial port1 "rts_pre_delay value
(config)>
l For rts_post_delay, enter the amount of time RTSis deasserted before completing
data transmission. The time is measured in milliseconds. The default is 0ms:
(config)> serial port1 rts_post_delay value
(config)>
n rs-422
l Enable Termination if you want to enable electrical termination on this serial port.
n rs-485
l Enable termination if you want to enable electrical termination on this serial port:
(config)> serial port1 termination true
(config)>
l Enable full_duplex if you want to enable full duplex communication on this serial
port:

Digi Connect EZ Mini Specifications

General

Brand	Digi
Model	Connect EZ Mini
Category	Server
Language	English