Services Location information
Digi Connect EZ Mini User Guide
377
4. Set the hostname or IP address of the remote host to which location messages will be sent:
(config service location forward 0)> server host
(config service location forward 0)>
5. Set the communication protocol to either upd or tcp:
(config service location forward 0)> protocol protocol
(config service location forward 0)>
6. Set the TCP or UDP port on the remote host to which location messages will be sent:
(config service location forward 0)> server_port 8000
(config service location forward 0)>
7. Set the number of Location update intervals to wait before forwarding location data to this
server. See Configure the location service for more information about setting the Location
update interval.
(config service location forward 0)> interval_multiplier int
(config service location forward 0)>
8. Set the protocol type for the messages. Allowed values are taip or nmea; the default is taip:
(config service location forward 0)> type nmea
(config service location forward 0)>
(Optional) If the protocol type is set to nmea:
a. Configure a Talker ID.
The talker IDis a two-character prefix in the NMEAmessage that identifies the source
type. The talker ID set here will override the talker ID from all sources, and all forwarded
sentences will use the configured ID.
i. Use the ? to determine available talker IDs:
(config service location forward 0)> talker_id ?
Talker ID: Setting a talker ID will override the talker ID from all
remote
sources, and all forwarded sentences from remote sources will use
the configured
ID.
Format:
Default
GA
GB
GI
GL
GN
GP
GQ
Default value: Default