Services Location information
Digi Connect EZ Mini User Guide
378
Current value: Default
(config service location forward 0)>
ii. Set the talker ID:
(config service location forward 0)> talker_id value
(config service location forward 0)>
The default setting is Default, which means that the talker ID provided by the source will
be used.
b. Determine the behavior when fix is invalid:
(config service location forward 0)> no_fix value
(config service location forward 0)>
where value is one of:
n none: No messages are sent.
n empty: Send messages with empty fields.
n last_fix: Send messages with information from the last valid fix.
The default is empty.
9. (Optional) Set the text to prepend to the forwarded message. Two variables can be included in
the prepended text:
n %s: Includes the Connect EZ device's serial number in the prepended text.
n %v: Includes the vehicle ID in the prepended text.
(config service location forward 0)> prepend __|%s|__|%v|__
(config service location forward 0)>
10. (Optional) Set the vehicle ID.
Allowed value is a four digit alphanumerical string (for example, 01A3 or 1234). If no vehicle ID
is configured, this setting defaults to 0000.
(config service location forward 0)> vehicle-id 1234
(config service location forward 0)>
11. (Optional) Provide a description of the remote host:
(config service location forward 0)> label "Remote host 1"
(config service location forward 0)>
12. (Optional) Specify types of messages that will be forwarded. Allowed values vary depending on
the message protocol type. By default, all message types are forwarded.
n If the message protocol type is NMEA:
Allowed values are:
l gga: Reports time, position, and fix related data.
l gll: Reports position data: position fix, time of position fix, and status.
l gsa: Reports GPS DOP and active satellites.
l gsv: Reports the number of SVs in view, PRN, elevation, azimuth, and SNR.
To Next Page
Loading...
Need help?
General