Digi Connect EZ Mini User Guide
8
Firmware configuration
Review Connect EZ default settings 39
Local WebUI 39
Digi Remote Manager 39
Default interface configuration 39
Other default configuration settings 39
Change the default password for the admin user 40
Configuration methods 41
Using Digi Remote Manager 42
Access Digi Remote Manager 42
Using the local web interface 43
Log out of the web interface 43
Use the local RESTAPI to configure the Connect EZ device 43
Use the GETmethod to return device configuration information 43
Use the POST method to modify device configuration parameters and list arrays 46
Use the DELETE method to remove items from a list array 46
Access the terminal screen from the web UI 47
Using the command line 49
Access the command line interface 49
Log in to the command line interface 49
Exit the command line interface 50
Interfaces
Define a static IPaddress 51
IPaddress and netmask 52
Wide Area Networks (WANs) 52
Wide Area Networks (WANs) 53
Configure WAN priority and default route metrics 53
Configure SureLink active recovery to detect WAN failures 55
Configure the device to reboot when a failure is detected 69
Disable SureLink 76
Configure a Wide Area Network (WAN) 85
Show WAN status and statistics 90
Delete a WAN 92
Show SureLink status and statistics 93
Show SureLink State 94
Show SureLink status for all interfaces 94
Show SureLink status for a specific interface 95
Show SureLink status for all IPsec tunnels 95
Show SureLink status for a specific IPsec tunnel 96
Show SureLink status for all OpenVPN clients 96
Show SureLink status for a specific OpenVPN client 97
Configure a TCP connection timeout 97
Serial port
Default serial port configuration 99
Serial mode options 99
View serial port information 99
Default serial port configuration 99
Configure Login mode 100
Configure Remote Access mode 105
To Next Page
Loading...
Need help?
General