254 Faxing (DocuPrint CM215 f/CM215 fw Only)
Sending a Delayed Fax
The Delayed Start mode can be used to save scanned documents for transmission at a specified time
to take advantage of lower long distance rates.
1 Load the document(s) facing up with top edge in first into the ADF or place a single document
facing down on the document glass and close the document cover.
See also:
• "Loading an Original Document on the ADF" on page 244
• "Loading an Original Document on the Document Glass" on page 245
2 Press the (Fax) button.
3 Adjust the document resolution to suit your fax needs.
See also:
• "Resolution" on page 246
• "Lighter/Darker" on page 248
4 Select Delayed Start, and then press the button.
5 Select On, and then press the button.
6 Enter the start time using the numeric keypad or press the or button to select the start time,
and then press the button.
7 Select Fax to, and then press the button.
8 Select Keypad, and then press the button.
9 Enter the fax number of the remote fax machine by one of the following way.
• Select Fax to, and then press the button. Select Keypad, and then press the button.
Enter the fax number of the remote fax machine using the numeric keypad, and then press the
button.
• Press the One-touch button, and then press the button.
• Press the (Address Book) button, select All Entries, Group Dial, or Search using the
button, and then press the button.
See also:
• "Automatic Dialing" on page 271
10 Press the (Start) button.
Once the Delayed Start mode is activated, your printer stores all the documents to be faxed to its
memory and sends them at the specified time. After faxing in the Delayed Start mode is complete, the
data in the memory will be cleared.
To Next Page
Loading...
Need help?
General
