308 Using the Operator Panel Menus and Keypad
• Number of Redial
Purpose:
To specify the number of redial attempts to make when the destination fax number is busy, within the
range of 0 to 9. If you enter 0, the printer will not redial. The default is 3.
• Redial Delay
Purpose:
To specify the interval between redial attempts within the range of 1 to 15 minutes. The default is one
minute.
• Junk Fax Setup
Purpose:
To reject faxes sent from unwanted numbers by accepting faxes only from the fax numbers registered
in the Address Book.
Values:
NOTE:
• Be sure to register the fax numbers you want to accept faxes from in the Address Book before using Junk
Fax Setup
.
• Remote Receive
Purpose:
To receive a fax by pressing a remote receive code on the external telephone after picking up the
handset of the telephone.
Values:
• Remote Rcv Tone
Purpose:
To specify the remote receive code in two digits to start Remote Receive.
• Fax Header
Purpose:
To print the information of sender on the header of faxes.
Values:
Off* Does not reject faxes sent from unwanted numbers.
On Rejects faxes sent from unwanted numbers.
Off* Does not receive a fax by pressing a remote receive code on the
external telephone.
On Receives a fax by pressing a remote receive code on the external
telephone.
Off Does not print the information of sender on the header of faxes.
On* Prints the information of sender on the header of faxes.
To Next Page
Loading...
Need help?
General
