Troubleshooting 367
îš„ The Output Is Too Light
NOTE:
• If the problem continues even though you have taken suggested actions described above, contact the Fuji
Xerox local representative office or an authorised dealer.
Problem Action
The output is too light. The toner cartridges may be low or need to be replaced. Confirm the
amount of toner in each toner cartridge.
1 Check the toner level in the Consumables tab in the Printer
Status window of the SimpleMonitor.
2 Replace the toner cartridges as necessary.
Verify that the print media is dry and the correct print media is used.
If not, use the print media recommended for the printer.
See also:
• "Usable Print Media" on page 120
Try changing the paper type setting in the print driver. The following
procedure uses the Windows print driver as an example.
1 On the Paper/Output tab in Printing Preferences of the print
driver, change the Paper Type setting.
2 Load dry (not damp) and correct size print media, and then click
Print Test Page in the Properties window of the print driver.
Disable the toner saving feature in the print driver.
See also:
• "Conserving Supplies" on page 436
To Next Page
Loading...
Need help?
General
