Using the Operator Panel Menus and Keypad 305
•IP Filter
NOTE:
• The IP Filter feature is supported for IPv4 addresses and available only for LPD or Port 9100.
Purpose:
To block data received from certain IP addresses through the network. You can set up to five IP
addresses. To make any changes effective, turn off the printer and then turn it back on.
Values:
• Initialize NVM
Purpose:
To initialize network data stored in Non-Volatile Memory (NVM). After executing this function and
rebooting the printer, all network settings are reset to their default values.
Values:
• Wi-Fi (DocuPrint CM215 fw Only)
Purpose:
To enable the wireless connection.
Values:
NOTE:
• This item is displayed only when the Ethernet cable is disconnected.
• When you use the USB connection and do not use the wireless connection, you need to disable Wi-Fi.
Fax Settings (DocuPrint CM215 f/CM215 fw Only)
Use the Fax Settings menu to configure the basic fax settings.
NOTE:
• Asterisk (*) is the factory default setting.
No.n/Address
(n is 1 - 5.)
Sets the IP address for Filter n.
No.n/Mask
(n is 1 - 5.)
Sets the address mask for Filter n.
No.n/Mode
(n is 1 - 5.)
Reject Rejects an access from the specified IP address.
Accept Accepts an access from the specified IP address.
Off* Disables the IP Filter feature for Filter n.
Yes
No*
Off
On*
To Next Page
Loading...
Need help?
General
