Faxing (DocuPrint CM215 f/CM215 fw Only) 289
îš„ Available Fax Setting Options
You can use the following setting options for configuring the fax system:
Option Description
Receive Mode Telephone Automatic fax reception is turned off. You can receive a fax by
picking up the handset of the external telephone, pressing the
remote receive code, and then pressing the (Start) button.
FAX * Automatically receives faxes.
Telephone/Fax When the printer receives an incoming fax, the external
telephone rings for the time specified in Auto Rec TEL/FAX,
and then the printer automatically receives a fax. If an
incoming call is not a fax, the printer beeps from the internal
speaker indicating that the call is a telephone call.
Ans
Machine/Fax
The printer can share a telephone line with an answering
machine. In this mode, the printer will monitor the fax signal
and pick up the line if there are fax tones. If the phone
communication is using serial transmission in your region, this
mode is not supported.
DRPD Before using the Distinctive Ring Pattern Detection (DRPD)
option, a distinctive ring service must be installed on your
telephone line by the telephone company. After the telephone
company has provided a separate number for faxing with a
distinctive ring pattern, configure the fax setup to monitor for
that specific ring pattern.
Auto Rec Fax Sets the interval at which the printer goes into the fax receive mode after receiving
an incoming call.
Auto Rec
TEL/FAX
Sets the interval at which the printer goes into the fax receive mode after the
external telephone receives an incoming call.
Auto Rec
Ans/FAX
Sets the interval at which the printer goes into the fax receive mode after the
external answering machine receives an incoming call.
Line Monitor Sets the volume of the line monitor, which audibly monitors a transmission through
the internal speaker until a connection is made.
Ring Tone
Volume
Sets the volume of the ring tone, which indicates that an incoming call is a telephone
call through the internal speaker when Receive Mode is set to Telephone/Fax.
Line Type Sets the line type.
Tone/Pulse Sets the dialing type.
NOTE:
• This menu is not displayed when Region is set to Australia.
Interval Timer Specifies the interval between transmission attempts.
Number of
Redial
Specifies the number of redial attempts to make when the destination fax number is
busy. If you enter 0, the printer will not redial.
Redial Delay Specifies the interval between redial attempts.
Junk Fax Setup Sets whether to reject faxes sent from unwanted numbers by accepting faxes only
from the fax numbers registered in the Address Book.
Remote Receive Sets whether to receive a fax by pressing a remote receive code on the external
telephone.
Remote Rcv
Tone
Specifies the remote receive code in two digits to start Remote Receive.
Fax Header Sets whether to print the information of sender on the header of faxes.
To Next Page
Loading...
Need help?
General
