Fuji Xerox DocuPrint CM215 series User Manual

304 Using the Operator Panel Menus and Keypad
•TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on.
Values:
NOTE:
• When you set an IP address in IPv6 mode, use the CentreWare Internet Services. For more information, refer
to the Help on the CentreWare Internet Services.
•Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and
then on.
Values:
IP Mode Dual Stack* Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv4 Get IP
Address
DHCP/AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Enables the IP address entered on the operator
panel.
IP Address Manually sets the IP address allocated to the
printer.
Subnet Mask Manually sets the subnet mask.
Gateway Address Manually sets the gateway address.
LPD Disable Disables the Line Printer Daemon (LPD) port.
Enable* Enables the LPD port.
Port 9100 Disable Disables the Port 9100 port.
Enable* Enables the Port 9100 port.
WSD Disable Disables the Web Services on Devices (WSD) port.
Enable* Enables the WSD port.
SNMP Disable Disables the Simple Network Management Protocol (SNMP)
UDP port.
Enable* Enables the SNMP UDP port.
StatusMessenge
r
Disable Disables the StatusMessenger feature.
Enable* Enables the StatusMessenger feature.
Internet
Services
Disable Disables an access to the CentreWare Internet Services
embedded in the printer.
Enable* Enables an access to the CentreWare Internet Services
embedded in the printer.
Bonjour(mDNS) Disable Disables the Bonjour (mDNS).
Enable* Enables the Bonjour (mDNS).

Fuji Xerox DocuPrint CM215 series Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CM215 series
Category	Printer
Language	English