Furuno FELCOM 250 Service Manual

 4.1 Overview
4-1
4.1 Overview
Handset: The settings for the phone function will need to be made for both the
Communication unit and the Handset.
Analog terminal(TEL/FAX): The settings for the phone function will need to be made
the Communication unit.
The Communication unit requires to have the Handsets and the Analog terminals
registered in the SIP server, and the Handset requires to be set as client terminal for the
SIP server. In other words, if the SIP server can acknowledge the registered Handset as
client terminal, phone calls and extension calls will be available.
4.1.1 Overview
1. Settings on the Web MMI 
The items requiring setting are Analog ports, Incoming indicator, and PBX settings
which you can reach via Settings -> Basic settings. “Contact” menu refers to the phone
number of the called party. Registration (each Handset) can be made via the Handset,
too. Make the settings as necessary.
Table 4.1.1 Items requiring setting on the Web MMI 
Menu Menu-1 Menu-2 Notes Page
GPS
Analog ports
Specifying the service type for the
analog device connected to the
TEL1 – 4 port, and the setting for
the extension number
4-7
Incoming indicator
ON/OFF settings for the ringing for
TEL, FAX, and UDI/RDI, and their
pattern settings
4-28
Serial port
Satellite
OTA
Basic
settings
Incoming routing
The settings for the routes of the
TEL and FAX incoming calls.
4-20
Call limit
Settings for the TEL calling
limitations
4-25
Group
Settings for grouping the extension
lines
4-26
Settings
PBX
settings
Extension
Registering the SIP server
Registering the Handset extension
numbers, passwords, and Notes
4-12
Contact Registering the TEL/SMS contacts 4-29


Chapter 4. Settings for TEL/FAX

Furuno FELCOM 250 Specifications

General

Brand	Furuno
Model	FELCOM 250
Category	Marine GPS System
Language	English