EasyManuals Logo
Home>Furuno>Marine GPS System>FELCOM 250

Furuno FELCOM 250 Service Manual

Furuno FELCOM 250
462 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #331 background imageLoading...
Page #331 background image

11.2 Antenna Unit: FB-1500/1250
11-16
IF Module:
An interface between the Antenna unit and the Communication unit, and
consists of the Duplexer, Multiplexer, ASK Modem, and 6.5 V/28 V SMPS
(Switched-Mode Power Supply).
GPS Module:
A GPS antenna, GPS LNA. It transmits the received data to the
Communication unit in 4 MHz ASK signal. It is a module commonly used for
FB-1500 and FB-1250.
2. Transmitting and Receiving Circuit
The Antenna unit and the Communication units are connected with a coaxial cable.
Antenna coaxial cable uses; 8D-FB-CV: 30 m/40 m/50 m, 12D-SFA-CV: 100 m. When
you wish to use any other coaxial cable than the one described above for test purpose,
make sure to have the loss of 9 dB (1.6 GHz) or below.
The coaxial cable has the following signal superimposed.
x 42 V : Power supply for the Antenna unit.
(Approx. 1.5 A at maximum for both FB-1500 and FB-1250)
x 4 MHz ASK signal : Control signal between the Antenna unit and the
Communication unit, and is Simplex communication.
The specifications for the ASK interface is;
communication speed: 38400 bps, data length: 8 bit,
parity: non, stop bit: 1 bit, flow control: N/A,
frequency: 4MHz
x Transmitting signal : 1626.5 to 1660.5 MHz
x Receiving signal : 1525.0 to 1559.0 MHz

Table of Contents

Other manuals for Furuno FELCOM 250

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Furuno FELCOM 250 and is the answer not in the manual?

Furuno FELCOM 250 Specifications

General IconGeneral
BrandFuruno
ModelFELCOM 250
CategoryMarine GPS System
LanguageEnglish

Related product manuals