10.6 Service
10-26
10.6.1.2 Free Command and ASK Line Monitor
You can enter the Antenna control command (binary) and confirm the response via the
ASK line monitor, but this will not be used at the field.
When you have executed the procedure, make sure to restart the Antenna. To restart the
Antenna, turn the power of the Antenna off once, or select Service -> Restart -> ADE,
ATB, or HPA.
Reference) Command usage example
Receipt level required for tracking the Antenna: When you wish to request for the
RSSI (Received Signal Strength Indicator) to ATB, set the Monitor to “Enable”, and
then monitor the control signal between the Antenna and the Communication unit:
ASK signal in the Monitor box.
The command data for ATB RSSI REQ is
“FF 13 13”(Header:FF_data: 13_Checksum: 13), and therefore, enter “atb 13”
(atb_data:13) into the Free command column.
The response for that command will be displayed in the Monitor box.
To Next Page
Loading...
Need help?
General
