I
-
System Measurements
Making System Measurements
Step 3. Enter the location code
1.
Press SYSTEM
MEAS
2.
Press ENTER LOCATION.
3. Press the data keys to enter the location code. The location code can be up
to seven digits long. If you make a mistake, you can use the back space
key to correct the location code. The back space key
((W))
is on the
lower right corner of the analyzer’s front panel, next to the
(ENTER)
key.
4. Press (ENTER) when the location code has been entered.
ENTER LOCATION allows you to enter a location code. The location code is
only for your convenience; it is meant to help you keep track of where the
data originated. The location code you enter will be stored and printed with
the data.
ENTER
Location
Code using the
keypad
(ENTER number, then press the ENTER
key)
89112
NOW
23s
1993
Figure 3-5. Enter location Menu
3-10
To Next Page
Loading...
Need help?
General
