Program Codes 419
EIA CODE DESCRIPTION
M36 Tvalue Process Select “T” where T value selects the process
1- Plasma 1
2- Plasma 2
3- Marker 1
4- Marker 2
5- Laser
M37 Tvalue (1-20) Select Station “T” where T = 1 through 20
M38 Tvalue (1-20) Deselect Station “T” where T = 1 through 20
M40 Start of Subroutine
M40 Xvalue Start of Subroutine. Executes the repeat X times
M41 End of Subroutine
M48 Speed Override Enable
M49 Speed Override Disable
M50 Height Sensor Disable
M51 Txx.xx Height Sensor Enable (Temporary Optional Time Delay in seconds before
Enable)
M52 Height Sensor Disable and Raise Torch
M53 Height Sensor Enable and Lower Torch
M65 End of Program (same as M02) or Auto Reload
M72 Marker Offset 2 Off
M73 Marker Offset 2 On
M75 A Axis/Tilt Go to Home Command - Rapid Index
M76 C Axis/Rotate Go to Home Command - Rapid Index
M77 Go to Home position Y Axis
M78 Go to Home position X Axis
M79 Tvalue (1-4) Go To Home Position (1-4)
M90 Aligns CBH / Rotator to Tangent angle of next cut segment
M90- Align rotator negative, when not using shortest path motion
M274 Marker Offset 3 Off
M275 Marker Offset 3 On
M276 Marker Offset 4 Off
M277 Marker Offset 4 On
M278 Marker Offset 5 Off
M279 Marker Offset 5 On
M280 Marker Offset 6 Off
M281 Marker Offset 6 On
M282 Marker Offset 7 Off
M283 Marker Offset 7 On
M284 Marker Offset 8 Off
M285 Marker Offset 8 On
M286 Marker Offset 9 Off
M287 Marker Offset 9 On
M288 Marker Offset 10 Off
M289 Marker Offset 10 On
M290 Marker Offset 11 Off
M291 Marker Offset 11 On
M292 Marker Offset 12 On
M293 Marker Offset 12 On
M301 Assigns the current X/Y position to Home Position 1
M302 Assigns the current X/Y position to Home Position 2
M303 Assigns the current X/Y position to Home Position 3
M304 Assigns the current X/Y position to Home Position 4
M305 Assigns the current X/Y position to Home Position 5
M306 Assigns the current X/Y position to Home Position 6
M307 Assigns the current X/Y position to Home Position 7
To Next Page
Loading...
Need help?
General
