.
OPERATION
TRANSPORTATION
OPERATION
TRANSPORTATION
3. Install wire ropes, slings, etc. matched to the weight of the
machine to the lifting points as shown in the diagram on the
right.
NOTICE
Use protectors to prevent the wire rope from being cut on sharp corners
and to prevent the wire rope from cutting into the machine bodywork.
When using a spreader bar, select an ample width to prevent contact
with the machine.
4.
After setting the wire ropes, lift up the machine and stop at 100
to 200 mm (3.9 to 7.9 in) above the ground, and check that the
wire ropes are not slack and the machine is level, then lift up
slowly.
PRECAUTIONS FOR TRANSPORTATION
WARNING
Determine the route for transporting the machine by taking into account the width, height and weight of the machine.
Obey all state and local laws governing the weight, width and length of a load. Observe all regulations governing
wide loads.
TRAVELING ON ROADS
When traveling on paved roads, use flat shoes to protect their surface.
Even when travelling a short distance, always place boards to protect the road surface.
REMARK
Note that the asphalt road becomes soft in summer.
3 - 136
To Next Page
Loading...
