.
SAFETY
PRECAUTIONS FOR OPERATION
BATTERY
BATTERY HAZARD PREVENTION
Battery electrolyte contains sulphuric acid, and batteries generate flammable hydrogen gas, which may explode.
Mistaken handling can lead to serious injury or fire. For this reason, always observe the following precautions.
When the battery electrolyte is below LOWER LEVEL, don't either use or charge the battery. Otherwise, that may
cause explosion. Always carry out periodic checks of the battery electrolyte, and add distilled water up to UPPER
LEVEL.
For the method of checking the battery electrolyte, see "CHECK LEVEL OF BATTERY ELECTROLYTE (PAGE
4-48)".
When working with batteries, always wear safety glasses and rubber gloves.
Never smoke or use any flame near the battery.
If you spill acid on your clothes or skin, immediately flush the
area with large amount of water.
If acid gets into your eyes, flush them immediately with large
amount of water and seek medical attention.
Before working with batteries, turn the starting switch to the OFF position.
As there is a hazard that sparks will be generated, always do as follows.
Do not let tools or other metal objects make any contact between the battery terminals. Do not leave tools or other
metal objects lying around near the battery.
Always disconnect the negative (-) terminal (ground side) first when removing the battery; when installing the
battery, connect the positive (+) terminal first, and connect the ground last. Tighten the battery terminals securely.
Tighten the battery terminals securely.
Flammable hydrogen gas is generated when the battery is charged, so remove the battery from the chassis, take
it to a well-ventilated place, and remove the battery caps before charging it.
Tighten the battery caps securely.
Install the battery securely to the determined place.
2 - 24
To Next Page
Loading...
Need help?
General
