.
OPERATION
OPERATION
CHECK AFTER FINISHING WORK
BEFORE STOPPING ENGINE
Use the meters and caution lamps to check the engine coolant
temperature, engine oil pressure, fuel, and power train oil
temperature.
AFTER STOPPING ENGINE
1. Walk around the machine and check the work equipment, machine exterior, and undercarriage, also check for
any leakage of oil or coolant. If any problems are found, repair them.
2.
Fill the fuel tank.
3. Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4.
Remove any mud affixed to the undercarriage.
LOCKING
To prevent vandalism, there are locks in the following places.
Places that can be locked with the starting switch key.
Right and left engine side cover (1)
(left side: 2 places, right side: 2 places)
Cab door opener (3)
Cap with lock (4)
Radiator cap (if equipped)
Fuel tank cap (if equipped)
Hydraulic oil tank cap
Battery inspection cover (2)
Rear cover (5)
3 - 126
To Next Page
Loading...
Need help?
General
