.
OPERATION
OPERATION
CHECK BEFORE STARTING
Always check the items in this section before starting the engine each day.
CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL
WARNING
Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil
temperature to go down before performing this operation.
1.
Open the engine side cover on the left side of the chassis.
2.
Remove dipstick (G), and wipe the oil off with a cloth.
3. Fully insert dipstick (G) into filler pipe (F), then remove it.
4. The oil level should be between the H and L marks on dipstick
(G).
If the oil level is below the L mark, add engine oil through oil
filler (F).
5.
If the oil is adove the H mark, drain the excess engine oil from
drain plug (1), and check the oil level again.
6. If the oil level is correct, tighten the oil filler cap securely and
close the engine side cover.
REMARK
When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the
engine before checking.
If the machine is at an angle make it horizontal before checking.
When adding oil, remove the dipstick form the holder to release the air inside the crankcase.
3 - 78
To Next Page
Loading...
Need help?
General
