.
SAFETY
PRECAUTIONS FOR OPERATION
TRAVELING ON SLOPES
To prevent the machine from tipping over or slipping to the side, always do as follows.
When traveling on slops, keep the blade approxmately 20 to 30
cm (8 to 12 in) above the ground. In case of emergency, quickly
lower the blade to the ground to help the machine to stop. Apply
the brake and use the engine as a brake, if necessary.
Always travel straight up or down a slope. Traveling at an angle
or across the slope is extremely dangerous.
Do not turn on slopes or travel across slopes. Always go down
to a flat place to change the position of the machine, then travel
on to the slope again.
Travel on grass, fallen leaves, or wet steel plates with low
speed. Even with slight slopes there is a hazard that the
machine may slip.
When driving down a slope, never shift gear or place the transmission in neutral. The engine brake cannot be
used and this creates a dangerous condition. Always travel downhill in the same speed range as when traveling
uphill.
When turning on a downhill ground, lower the travel speed.
USING BRAKES
When the machine is traveling, do not rest your foot on the brake pedal. If you travel with your foot resting on the
pedal, the brake will always be applied, and this will cause the brakes to overheat and fail.
Do not depress the brake pedal repeatedly if not necessary. If this is neglected, the brake will be overheated and
will not work when required.
When traveling downhill, use the braking force of the engine.
OPERATE CAREFULLY ON SNOW
Snow-covered or frozen surfaces are slippery, so be extremely careful when traveling or operating the machine,
and do not operate the levers suddenly. Even a slight slope may cause the machine to slip, so be particularly
careful when working on slopes.
With frozen ground surfaces, the ground becomes soft when the temperature rises, and this may cause the
machine to tip over or make it impossible for the machine to escape.
If the machine enters deep snow, there is a hazard that it may tip over or become buried in the snow. Be careful
not to leave the road shoulder or to get trapped in a snow drift.
When clearing snow, the road shoulder and objects placed beside the road are buried in the snow and cannot be
seen. There is a hazard of the machine tipping over or hitting covered objects, so always carry out operations
carefully.
When traveling on snow-covered slopes, never apply the brakes suddenly. Reduce the speed and use the engine
as a brake while appling the foot brake intermittently (depress the brake intermittently several times). If
necessary, lower the blade to the ground to stop the machine.
2 - 21
To Next Page
Loading...
Need help?
General
