.
SAFETY
GENERAL PRECAUTIONS
HANDRAILS AND STEPS
To prevent personal injury caused by slipping or falling off the machine, always do as follows.
Use the parts marked by arrow A in the diagrams when getting
on or off the machine.
Never use the parts marked by arrow B when getting on or off
the machine. Use them only when moving along the top of the
track or when checking or carrying out maintenance inside the
side cover, or when filling the tank with oil.
Never jump on or off the machine. In particular, never get on or
off a moving machine. This may cause serious injury.
To ensure safety, always face the machine and maintain
three-point contact (both feet and one hand, or both hands and
one foot) with the handrails and steps (including the track shoe)
to ensure that you support yourself.
Do not grip the control levers, or work equipment lock lever
when getting on or off the machine.
Never climb on the engine hood or covers where there are no
non-slip pads.
Before getting on or off the machine, check the handrails and
steps (including the track shoe). If there is any oil, grease, or
mud on the handrails or steps (including the track shoe), wipe it
off immediately. Always keep these parts clean. Repair any
damage and tighten any loose bolts.
Do not get on or off the machine while holding tools in your hand.
MOUNTING AND DISMOUNTING
Never jump on or off the machine. Never get on or off a moving machine.
If the machine starts to move when there is no operator on the machine, do not jump on to the machine and try
to stop it.
NO PEOPLE ON ATTACHMENTS
Never let anyone ride on the work equipment, or other attachments. There is a hazard of falling and suffering serious
injury.
CRUSHING OR CUTTING PREVENTION
The clearance around the work equipment will change according to the movement of the link. If you get caught, this
may lead to serious personal injury. Do not allow anyone to approach any rotating or telescoping part.
2 - 11
To Next Page
Loading...
