DETAILED CONTROLS AND GAUGES OPERATION
3-46
When operating in the rainy season or when it is desired to
remove the mist from the window glass or to dehumidify the air,
turn air conditioner switch (8) ON.
Use Air Conditioner with Care 3
NOTICE
q When running the air conditioner, always start with the engine running at low speed. Never start the
air conditioner when the engine is running at high speed. It will cause failure of the air conditioner.
q If water gets into the control panel or sunlight sensor, it may lead to unexpected failure, so be careful
not to let water get on these parts. In addition, never bring any flame near these parts.
q For the auto function of the air conditioner to work properly, always keep the sunlight sensor clean
and do not leave anything around the sunlight sensor that may interfere with its sensor function.
Ventilation
q If you smoke when the cooler is on, the smoke may start to hurt your eyes, so open the window and turn the
lever to FRESH for a while to remove the smoke while continuing the cooling.
q When running the air conditioner for a long time, turn the lever to the FRESH position once an hour to carry
out ventilation and cooling.
Temperature Control
When the cooler is on, set the temperature so that it feels slightly cool when entering the cab (5 or 6 °C) lower than
the outside temperature). This temperature difference is considered to be the most suitable for your health, so
always be careful to adjust the temperature properly.
Inspection and maintenance of Air Conditioner Equipped Machine 3
Inspection and maintenance of air conditioner (if equipped)
When carrying out inspection and maintenance of the air conditioner, follow the procedure given in the chart in
“CHECK AND ADJUST AIR CONDITIONER (4-38),CHECK, ADJUST AIR CONDITIONER COMPRESSOR BELT
TENSION (4-64),CLEAN AIR CONDITIONER FRESH/RECIRC FILTERS (4-59)“.
To Next Page
Loading...
Need help?
General
