OPERATION MACHINE OPERATIONS AND CONTROLS
3-69
Seat Belt 3
WARNING
q Before fitting the seat belt, check that there is no abnormality in the belt mount bracket or mounting
belt. If it is worn or damaged, replace the seat belt.
q Even if no abnormality can be seen in the belt, replace the seat belt every 3 years. The date of manu-
facture of the belt is shown on the back of the belt.
q Always wear the seat belt during operations.
q Fit the seat belt so that it is not twisted.
Fastening and Removing
This seat belt has a wind-in device, so it is not necessary to adjust the length.
Fastening Seat Belt
Hold grip (2) and pull the belt out from wind-in device (1), check
that the belt is not twisted, then insert tongue (3) into buckle (4)
securely.
When doing this, pull the belt lightly to check that it is properly
locked.
Removing Belt
Press button (5) in buckle (4), and remove tongue (3) from buckle (4).
The belt is automatically wound in, so hold grip (2) and return the belt slowly to wind-in device (1).
REMARK
For machines with a suspension seat,adjust the position of the
seat, then adjust tether belt (1). Install the tether belt so that it
is tensed when no one is sitting in the seat. (Only machines
equipped with suspension seat)
To Next Page
Loading...
Need help?
General
