MACHINE OPERATIONS AND CONTROLS OPERATION
3-96
GENERAL OPERATION INFORMATION 3
Traveling
Traveling over boulders, tree stumps, or other obstacles will
cause a big shock to the chassis (and in particular to the
tracks), and this will cause damage to the machine. For this
reason, always remove any obstacles or travel around them, or
take other steps to avoid traveling over such obstacles as far
as possible.
If there is no way to avoid traveling over an obstacle, reduce
the travel speed, keep the work equipment close to the ground,
and try to travel so that the center of the track passes over the
obstacle.
High Speed Travel
On uneven roadbeds, such as rockbed or uneven roads with
large rocks, travel at low speed. When traveling at high speed,
set the idler at the front of the machine.
q Press travel speed selector switch (1) to select the travel
speed.
Permissible Water Depth
NOTICE
When driving the machine out of water, if the angle of the
machine exceeds 15°C, the rear of the upper structure will
go under water, and water will be thrown up by the radiator
fan. This may cause the fan to break.
Be extremely careful when driving the machine out of
water.
Do not drive the machine in water deepen than of the center of
carrier roller (1).
Supply grease to the parts which have been under water for a
long time until the used grease is projected out of the bearings
(around the bucket pin, in particular).
To Next Page
Loading...
Need help?
General
